Honda CR-V: HazardWarning Button

Push the button between the center

Push the button between the center vents to turn on the hazard warning lights (four-way flashers). This causes all four outside turn signals and both indicators in the instrument panel to flash. Use the hazard warning lights if you need to park in a dangerous area near heavy traffic, or if your vehicle is disabled.

READ NEXT:

 Rear Window Defogger

The rear window defogger will clear fog, frost, and thin ice from the window. Push the defogger button to turn it on and off. The indicator in the button comes on to show the defogger is

 Parking Brake

To apply the parking brake, push the pedal down with your foot. To release it, push on the pedal again. The parking brake indicator on the instrument panel should go out when the parking

 Steering Wheel Adjustment

Make any steering wheel adjustment before you start driving. Adjusting the steering wheel position while driving may cause you to lose control of the vehicle and be seriously injured in

SEE MORE:

 Propeller Shaft

Propeller Shaft Inspection Universal Joint and Boots 1. Set the parking brake, then shift the transmission to the N position. 2. Raise the vehicle on a lift. 3. Check the center support bearing (A) for excessive play or rattle. If the center support has excessive play or rattle, replace the propel

 Front Driveshaft Reassembly

Exploded View NOTE: Refer to the Exploded View as needed during this procedure. Inboard Joint Side 1. Wrap the splines with vinyl tape (A) to prevent damaging to the inboard boot. 2. Install the inboard boot onto the drives haft, then remove the vinyl tape. Be careful not to damage the inboard boo

© 2016-2025 Copyright www.hcrv.net