Honda CR-V manuals

Honda CR-V: To Play an iPod

Honda CR-V (2006–2011) Owner's Manual / Features / Playing an iPod (EX-L model with navigation system) / To Play an iPod

This audio system can select and play the audio files on the iPod with the same controls used for the indash disc player. To play an iPod, connect it to the USB adapter cable in the upper glove box by using your dock connector. Press the AUDIO button beside the screen to show the audio display and touch the AUX icon. The ignition switch must be in the ACCESSORY (I) or ON (II) position. The iPod will also be recharged with the ignition switch in these positions.

The audio system reads and plays playable sound files on the iPod. The system cannot operate an iPod as a mass storage device. The system will only play songs stored on the iPod with iTunes.

iPod and iTunes are registered trademarks owned by Apple Inc.

READ NEXT:

 Voice Control System

You can select the AUX mode by using the navigation system voice control buttons, but cannot operate the play mode functions. iPods compatible with your audio system using the USB adapter cab

 Connecting an iPod

1. Open the upper glove box. 2. Push the release button to release the USB adapter cable. 3. Connect your dock connector to the iPod correctly and securely. 4. Install the dock connector

 To Change or Select Files

Use the SKIP button while an iPod is playing to change files. SKIP - Each time you press and release (preset 6), the player skips forward to the beginning of the next file. Press and releas

SEE MORE:

 MICU Input Test

NOTE: The MICU turns on the headlights (high beams) in a dim mode for the daytime running lights under the following conditions: The ignition switch is ON (II) The headlight switch is OFF The parking brake is released (parking brake switch OFF) If the vehicle is equipped with an opti

 DTC 45-1x ("x" can be 0 thru 9 or A thru F): No Signal From the Left Side Impact Sensor (second)

Special Tools Required SRS inflator simulator 07SAZ-TB4011A SRS simulator lead L 070AZ-SNAA300 NOTE: Before doing this troubleshooting procedure, review SRS Precautions and Procedures. 1. Erase the DTC memory. 2. Turn the ignition switch ON (II), and wait for 10 seconds. 3. Read the DTC. Is

© 2016-2025 Copyright www.hcrv.net