Honda CR-V: APP Sensor Signal Inspection

NOTE:

1. Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.

Honda CR-V. APP Sensor Signal Inspection

2. Turn the ignition switch ON (II).

3. Make sure the accelerator pedal is not pressed, then check the APP SENSOR in the DATA LIST with the HDS.

4. Make sure the accelerator pedal is not pressed, then check the APP SENSOR in the DATA LIST with the HDS.

Accelerator Pedal Module Removal/Installation

1. Disconnect the accelerator pedal module connector (A).

Honda CR-V. Accelerator Pedal Module Removal/Installation

2. Remove the accelerator pedal module (B).

NOTE: The APP sensor is not available separately.

Do not disassemble the accelerator pedal module.

3. Install the parts in the reverse order of removal.

READ NEXT:

 VTEC/VTC

Component Location Index ROCKER ARM OIL CONTROL VALVE Removal/Installation ROCKER ARM OIL PRESSURE SWITCH Removal/Installation CAMSHAFT POSITION (CMP)

 DTC Troubleshooting

 DTC P0010: VTC Oil Control Solenoid Valve Malfunction

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the H

SEE MORE:

 Airbags

Your vehicle has a supplemental restraint system (SRS) with front airbags to help protect the heads and chests of the driver and a front seat passenger during a moderate to severe frontal collision. Your vehicle also has side airbags to help protect the upper torso of the driv

 To Play a Disc

To load or play a disc, the ignition switch must be in the ACCESSORY (I) or ON (II) position. You operate the disc player with the same controls used for the radio. To select the disc player, press the CD/ AUX button. You will see ‘‘CD’’ in the display. Do not use discs wit

© 2016-2026 Copyright www.hcrv.net