Honda CR-V: Windshield Wipers and Washers

READ NEXT:

 Windshield Wiper

1. MIST 2. OFF 3. INT Intermittent 4. LO Low speed 5. HI High speed 6. Windshield washers Push the right lever up or down to select a position. MIST - The wipers run at high speed until

 WindshieldWashers

Pull the wiper control lever toward you, and hold it. The washers spray until you release the lever. The wipers run at low speed, then complete one more sweep after you release the lever.

 Rear Window Wiper and Washer

1. OFF When you turn the wiper switch to the ‘‘OFF’’ position, the wiper will return to its parked position. 2. Rotate the switch clockwise to turn the rear window wiper ON. The

SEE MORE:

 Intake Manifold and Exhaust System

Intake Manifold Removal and Installation Exploded View Removal 1. Remove the hood support rod, then use it as shown to prop the hood in the wide-open position. 2. Remove the bulkhead cover. 3. Disconnect the fan motor connectors (A) and hood switch connector (B), then remove the harness clips (C)

 DTC P0712: Short in ATF Temperature Sensor Circuit

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission. 1. Check the ATF temperature sensor voltage

© 2016-2025 Copyright www.hcrv.net