Honda CR-V: Outside Temperature Indicator
If equipped
This indicator displays the outside temperature in Fahrenheit (U.S.
models) or Celsius (Canadian models).
The temperature sensor is in the front bumper. Therefore, the temperature reading can be affected by heat reflection from the road surface, engine heat, and the exhaust from surrounding traffic.
This can cause an incorrect temperature reading when your speed is under 19 mph (30 km/h).
The sensor delays the display update until it reaches the correct outside temperature. This may take several minutes.
If the outside temperature is incorrectly displayed, you can adjust it up to +/-5°F in U.S. models (+/- 3°C in Canadian models) warmer or cooler.
NOTE: The temperature must be stabilized before doing this procedure.
To adjust the outside temperature display, press and hold the select/ reset knob for 10 seconds. The display changes as shown above.
Select the outside temperature indicator by turning the select/reset knob. The display begins to blink.
Push the same knob to enter this setting, then turn it to adjust the temperature. The following sequence will appear for each: 0, 1, 2, 3, 4, 5, -5, -4, -3, -2, -1, 0 (U.S.) or 0, 1, 2, 3, -3, -2, -1, 0 (Canada).
When it reaches the desired value, push the select/reset knob to enter the setting. You should see the new outside temperature displayed.
In certain weather conditions, temperature readings near freezing (32°F, 0°C) could mean that ice is forming on the road surface.
READ NEXT:
Check Fuel Cap Message
If your fuel fill cap is loose or
missing, a ‘‘CHECK FUEL CAP’’
message appears on the information
display after you start the engine.
Maintenance Minder
The information display in the
instrument panel shows you the
engine oil life and maintenance
service items when the ignition
switch is in the ON (II) position. This
information helps to kee
Controls Near the Steering Wheel
Controls Near the Steering Wheel
SEE MORE:
System Diagnostic Mode
Start-up procedure and Diagnosis Menu
1. Turn the ignition switch to the ON (II) position.
Press and hold the Menu, the Map/Guide, and the
Cancel buttons. Keep them pressed for
approximately 3 seconds. The display screen then
goes directly to the Diagnostic Menu.
DIAGNOSTIC MENU SCREEN
2. After th
To Select a File from iPod Menu
You can also select a file from any
list on the iPod menu: playlists,
artists, albums and songs. Press the
AUDIO button to display the screen,
then touch the iPodMENU icon.
Select the desired mode by touching
the appropriate icon, or move the
joystick, then press ENT.
Press the AUD
