Honda CR-V: General Information

Your vehicle has been designed primarily for use on pavement. But its higher ground clearance allows you to occasionally travel on unpaved roads, such as campgrounds, picnic sites, and similar locations. It is not designed for trail-blazing, mountain climbing, or other challenging offroad activities.

If you decide to drive on unpaved roads, you will find that it requires somewhat different driving skills.

Your vehicle will also handle somewhat differently than it does on pavement. So be sure to read this owner’s manual, pay special attention to the precautions and tips in this section, and get acquainted with your vehicle before you leave the pavement.

Improperly operating this

Improperly operating this vehicle on or off pavement can cause an accident or rollover in which you and your passengers could be seriously injured or killed.

Follow all instructions and guidelines in this owner’s manual.

Keep your speed low, and don’t drive faster than conditions permit.

READ NEXT:

 Important Safety Precautions

To avoid loss of control or rollover, be sure to follow all precautions and recommendations. Be sure to store cargo properly and do not exceed your cargo load limits. Wherever you drive, mak

 Check Out Your Vehicle

Before you leave the pavement, be sure to do all scheduled maintenance and service, and inspect your vehicle for any problems. Pay special attention to the condition of the tires, and check

 Remember

The route presents limits (too steep or bumpy roads). You have limits (driving skill and comfort). And your vehicle has limits (traction, stability, and power). Driving off-highway can be h

SEE MORE:

 Intermediate Shaft

Intermediate Shaft Removal 1. Drain the automatic transmission fluid. Reinstall the drain plug with a new washer. 2. Remove the right driveshaft. 3. Remove the flange bolt (A) and two dowel bolts (B). 4. Remove the intermediate shaft (A) from the differential. Hold the intermediate shaft horizon

 APP Sensor Signal Inspection

NOTE: This procedure checks the APP sensor in its fully closed position. In any other position, the APP sensor stores DTCs which are covered in other troubleshooting procedures. Check for Temporary DTCs or DTCs with the HDS before doing this procedure. If any DTCs are indicated, troubleshoot

© 2016-2025 Copyright www.hcrv.net