Honda CR-V: PCV System
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / PCV System
Component Location Index
- PCV VALVE
PCV Valve Inspection
1. Check the PCV valve (A), hoses (B), and connections for leaks or restrictions.
2. At idle, make sure there is a clicking sound from the PCV valve when the hose between the PCV valve and intake manifold is lightly pinched (A) with your fingers or pliers.
If there is no clicking sound, check the PCV valve washer for cracks or damage. If the washer is OK, replace the PCV valve and recheck.
PCV Valve Replacement
1. Disconnect the PCV hose.
2. Remove the PCV valve (A).
3. Install the parts in the reverse order of removal with a new washer (B).
READ NEXT:
EVAP System
Component Location Index
EVAPORATIVE EMISSION (EVAP)
CANISTER PURGE VALVE
Replacement
POWERTRAIN CONTROL MODULE (PCM)
General Troubleshooting Information
Replacement
DTC P0443: EVAP Canister Purge Valve
Circuit Malfunction
Special Tools Required
Vacuum pump/gauge, 0-30 in.Hg, Snap-on YA4000A
or equivalent, commercially available.
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and revie
SEE MORE:
DTC 91: VSA System
1. Check the brake system for leaks or mechanical
problems.
Is the brake system OK? (No brake fluid leakage,
no air trapped in the brake system, no brake pads
worn out.)
YES-Go to step 2.
NO-Repair the brake system, then recheck.
2. Turn the ignition switch ON (II).
3. Clear the DTC with the HDS
Accelerating and Braking
For better traction on all surfaces,
accelerate slowly and gradually build
up speed. If you try to start too fast
on wet soil, mud, snow, or ice, you
might not have enough traction to
get underway, and you may dig
yourself a hole. Starting with the
shift lever in second (2) gear will
© 2016-2025 Copyright www.hcrv.net
