Honda CR-V: Windshield Wipers and Washers

READ NEXT:

 Windshield Wiper

1. MIST 2. OFF 3. INT Intermittent 4. LO Low speed 5. HI High speed 6. Windshield washers Push the right lever up or down to select a position. MIST - The wipers run at high speed until

 WindshieldWashers

Pull the wiper control lever toward you, and hold it. The washers spray until you release the lever. The wipers run at low speed, then complete one more sweep after you release the lever.

 Rear Window Wiper and Washer

1. OFF When you turn the wiper switch to the ‘‘OFF’’ position, the wiper will return to its parked position. 2. Rotate the switch clockwise to turn the rear window wiper ON. The

SEE MORE:

 DTC P0962: Problem in A/T Clutch Pressure Control Solenoid Valve A Circuit

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information (see page 14-4). This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission. 1. Clear the DTC with the HD

 MICU Input Test

NOTE: Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A. 1. Turn the ignition switch OFF. 2. Disconnect the under-dash fuse/relay box connectors E, F, G, K, R, and T. NOTE: All connector views are wire side of female terminals. UNDER-DASH FUSE/RELAY BOX CONNECTOR E (42P) UNDER-D

© 2016-2025 Copyright www.hcrv.net