Honda CR-V: Sleep and Wake-up Mode Test

1. Shift to the sleep mode: Turn the ignition switch OFF, and remove the key. If the MICU receives no signals from the inputs listed below, it will go into sleep mode in less than 40 seconds.

2. Confirm the sleep mode: Check for voltage on the B-CAN communication line; there should be battery voltage in the sleep mode. Check the parasitic draw at the battery while shifting into the sleep mode; amperage should change from about 200 mA to less than 35 mA.

3. Shift to the wake up mode: When the ignition switch is turned ON (II), the MICU, gauge control module, immobilizer-keyless control unit-receiver, and PCM wake up at the same time without "talking" to each other through the communication lines.

When any switch in the multiplex integrated control system is turned on, it wakes up its related control unit which, in turn, wakes up the other units. After confirming the sleep mode, look in the following table for the switch most related to the problem. Operate that switch and see if its control unit wakes up.

NOTE: If any control unit is faulty and will not wake up, several circuits in the system will malfunction at the same time. The MICU is followed by a list of the switches and input signals that can wake it up.

Circuit Diagram

Honda CR-V. Circuit Diagram

READ NEXT:

 DTC Troubleshooting

DTC B1000: Communication Bus Line Error (Bus-off) 1. Clear the DTCs with the HDS. 2. Turn the ignition switch OFF, and then back ON (II). 3. Wait for 6 seconds or more. 4. Check for DTCs with the H

 MICU Input Test

NOTE: Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A. 1. Turn the ignition switch OFF. 2. Disconnect the under-dash fuse/relay box connectors E, F, G, K, R, and T. NOTE: All con

 Keyless/Power Door Locks/Security System

Component Location Index NAVIGATION UNIT or AUDIO UNIT IMMOBILIZER-KEYLESS CONTROL UNIT (Built-in receiver) MICU (Built into the under-dash fuse/relay box) HEADLIGHTS HORN HOOD SWITCH SECUR

SEE MORE:

 Steering Gearbox Overhaul

Exploded View Special Tools Required Cylinder end seal remover attachment 070AF-S7S0100 Valve seal ring sizing tool 07NAG-SR3090A Sleeve seal ring guide 07YAG-S2X0100 Sleeve seal ring sizing tool, 36 mm 07ZAG-S5A0100 Attachment, 28 x 30 mm 07946-1870100 Driver 07749-0010000 Piston seal ri

 General Information

Your vehicle has been designed primarily for use on pavement. But its higher ground clearance allows you to occasionally travel on unpaved roads, such as campgrounds, picnic sites, and similar locations. It is not designed for trail-blazing, mountain climbing, or other challenging offr

© 2016-2025 Copyright www.hcrv.net