Honda CR-V: Compass Calibration
If you see ‘‘- -’’ in the direction display when you turn the ignition switch to the ON (II) position, the compass is self-calibrating.
The compass may need to be manually calibrated after exposure to a strong magnetic field. If the compass display changes to ‘‘- -’’ and the calibrate indicator blinks, or the display does not show any direction and the compass is not selfcalibrating, do the following.
1. Drive the vehicle slowly in three complete circles.
NOTE: Do this procedure in an open area, away from buildings, power lines, and other vehicles.
2. When the display goes from ‘‘- -’’ or blank to an actual heading, the unit is calibrated and the display returns to normal.
READ NEXT:
Compass Zone Selection
In most areas, there is a variation
between magnetic north and true
north. Zone selection is required so
the compass can compensate for this
variation. To check and select the
zone, do this:
Security System
If equipped
The security system helps to protect
your vehicle and valuables from theft.
The horn sounds and a combination
of headlights, parking lights, side
marker lights and taillights flash
Rearview Camera and Monitor
On EX-L model with navigation system
Whenever you shift to reverse (R)
with the ignition switch in the ON
(II) position, the rearview is shown
on the navigation system screen.
For the best p
SEE MORE:
Tire Labeling
The tires that came on your vehicle
have a number of markings. Those
you should be aware of are described
below.
Tire Size
Whenever tires are replaced, they
should be replaced with tires of the
same size. Below is an example of
tire size with an explanation of what
each component m
DTC Troubleshooting
DTC B1026: Front Passenger's Door Lock
Switch Signal Error (LOCK/UNLOCK)
NOTE: If you are troubleshooting multiple DTCs, be
sure to follow the instructions in B-CAN System Diagnosis Test Mode A.
1. Clear the DTCs with the HDS.
2. Turn the ignition switch OFF, and then back ON (II).
3. Operate the
© 2016-2025 Copyright www.hcrv.net
