Honda CR-V: TripMeter
This meter shows the number of miles (U.S.) or kilometers (Canada) driven since you last reset it.
There are two trip meters: Trip A and Trip B. Switch between these displays by pressing the select/reset knob repeatedly.
Each trip meter works independently, so you can keep track of two different distances.
When you turn the ignition switch to the ON (II) position, the last selection is displayed.
To reset a trip meter, display it, and then press and hold the select/reset knob until the number resets to ‘‘0.0’’.
READ NEXT:
Instant Fuel Economy
This display shows the instant fuel
economy you are getting.
It shows the number of mpg (U.S.)
or l/100 km (Canada).
Average Fuel Economy
When either of the trip meters (trip
A or B) is displayed, your vehicle’s
average fuel economy since you last
reset that tripmeter can be shown
on the information display (mpg on
U.S. mode
Range (Estimated Distance)
This display shows the estimated
distance you can travel on the fuel
remaining in the tank.
This distance is estimated from the
fuel economy you have achieved
over the last few miles (kilomet
SEE MORE:
MICU Input Test
1. Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A, and
check the No.8
(10 A), No. 10 (7.5 A), and No. 38 (30 A) fuses in the under-dash fuse/relay
box.
2. Disconnect under-dash fuse/relay box connectors E, F, S, and T.
NOTE: All connector views are wire side of female termin
DTC 12, 14, 16, 18: Wheel Sensor (Electrical
Noise/Intermittent Interruption)
NOTE:
If the ABS and other indicators come on because of
electrical noise, the indicators will go off when you
test-drive the vehicle at 10 mph (15 km/h) or more
and noise is gone.
An incorrectly installed wheel bearing can cause one
of these DTCs.
1. Turn the ignition switch OFF.
2. Check
© 2016-2025 Copyright www.hcrv.net
