Honda CR-V: Windshield Wipers and Washers

READ NEXT:

 Windshield Wiper

1. MIST 2. OFF 3. INT Intermittent 4. LO Low speed 5. HI High speed 6. Windshield washers Push the right lever up or down to select a position. MIST - The wipers run at high speed until

 WindshieldWashers

Pull the wiper control lever toward you, and hold it. The washers spray until you release the lever. The wipers run at low speed, then complete one more sweep after you release the lever.

 Rear Window Wiper and Washer

1. OFF When you turn the wiper switch to the ‘‘OFF’’ position, the wiper will return to its parked position. 2. Rotate the switch clockwise to turn the rear window wiper ON. The

SEE MORE:

 Shafts and Clutches

Mainshaft Disassembly, Inspection, and Reassembly 1. Inspect the thrust needle bearing and the needle bearing for galling and rough movement. 2. Inspect the splines for excessive wear and damage. 3. Check shaft bearing surface for scoring and excessive wear. 4. Before installing the O-rings, wra

 DTC 82-14: No Signal From the Front Passenger's Weight Sensor (front inner side)

NOTE: Before doing this troubleshooting procedure, review SRS Precautions and Procedures. 1. Erase the DTC memory. 2. Read the DTC. Is DTC 82-14 indicated? YES-Go to step 3. NO-Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. 3. From the SRS INSPE

© 2016-2025 Copyright www.hcrv.net