Honda CR-V: To Play the FM/AM Radio

The ignition switch must be in the ACCESSORY (I) or ON (II) position.

Turn the system on by pushing the FM or AM button. Adjust the volume by turning the VOL/SELECT knob.

The band and frequency that the radio was last tuned to are displayed.

To change bands, press the AM or FM button. On the FM band, ST will be displayed if the station is broadcasting in stereo. Stereo reproduction in AM is not available.

READ NEXT:

 To Select a Station

You can use any of five methods to find radio stations on the selected band: tune, seek, scan, the preset buttons, and auto select. TUNE - Use the SEEK button to tune to a desired frequency.

 Adjusting the Sound

Press the sound ( ) button to select an appropriate setting: bass, treble, fader, balance, subwoofer (if equipped), and SVC (speed-sensitive volume compensation). Turn the VOL/SELECT knob

 Audio System Lighting

You can use the instrument panel brightness control knob to adjust the illumination of the audio system. The audio system illuminates when the parking lights are on, even if the system is tu

SEE MORE:

 DTC P1549: Charging System High Voltage

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. If a high voltage battery (24 V, etc.) is connected to the vehicle, this DTC can be stored. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the HDS.

 Under-hood/dash Fuse/Relay Box

Under-hood Fuse/Relay Box Removal and Installation Removal 1. Make sure you have the anti-theft codes for the audio and navigation system. If equipped with XM radio, write down the XM radio presets. 2. Make sure the ignition switch is OFF. 3. Disconnect the negative battery cable, then disconnect

© 2016-2025 Copyright www.hcrv.net