Honda CR-V: Daytime Running Lights

With the headlight switch in the off or the high beam position, the high beam headlights and the high beam indicator come on with reduced brightness when you turn the ignition switch to the ON (II) position and release the parking brake. They remain on until you turn the ignition switch off, even if you set the parking brake.

The headlights revert to normal operation when you turn them on with the switch.

READ NEXT:

 Instrument Panel Brightness

You can change the instrument panel brightness only when the light switch is on. Turn the knob on the lower part of the instrument panel to adjust the brightness. You will hear a beep wh

 HazardWarning Button

Push the button between the center vents to turn on the hazard warning lights (four-way flashers). This causes all four outside turn signals and both indicators in the instrument panel t

 Rear Window Defogger

The rear window defogger will clear fog, frost, and thin ice from the window. Push the defogger button to turn it on and off. The indicator in the button comes on to show the defogger is

SEE MORE:

 Electronic Throttle Control System

Component Location Index ELECTRONIC THROTTLE CONTROL SYSTEM (ETCS) CONTROL RELAY (RELAY SOCKET F) POWERTRAIN CONTROL MODULE (PCM) General Troubleshooting Information Replacement THROTTLE ACTUATOR and THROTTLE POSITION (TP) SENSOR ACCELERATOR PEDAL MODULE

 Load Limits

Total Trailer Weight: The maximum allowable weight of the trailer and everything in or on it must not exceed 1,500 lbs (680 kg). Towing a load that is too heavy can seriously affect your vehicle’s handling and performance. It can also damage the engine and drivetrain. Tongue Lo

© 2016-2025 Copyright www.hcrv.net