Honda CR-V: ThreeWay Catalytic Converter

The three way catalytic converter contains precious metals that serve as catalysts, promoting chemical reactions to convert the exhaust gasses without affecting the metals.

The catalytic converter is referred to as a three-way catalyst, since it acts on HC, CO, and NOx. A replacement unit must be an original Honda part or its equivalent.

The three way catalytic converter must operate at a high temperature for the chemical reactions to take place. It can set on fire any combustible materials that come near it. Park your vehicle away from high grass, dry leaves, or other flammables.

A defective three way catalytic

A defective three way catalytic converter contributes to air pollution, and can impair your engine’s performance.

Follow these guidelines to protect your vehicle’s three way catalytic converter.

Always use unleaded gasoline.

Even a small amount of leaded gasoline can contaminate the catalyst metals, making the three way catalytic converter ineffective.

Keep the engine well maintained.

Have your vehicle diagnosed and repaired if it is misfiring, backfiring, stalling, or otherwise not running properly.

READ NEXT:

 Emissions Testing

Testing of Readiness Codes If you take your vehicle for an emissions test shortly after the battery has been disconnected or gone dead, it may not pass the test. This is because of certain ‘

 Warranty and Customer Relations

 Customer Service Information

Honda dealership personnel are trained professionals. They should be able to answer all your questions. If you encounter a problem that your dealership does not solve to your satisfaction, pl

SEE MORE:

 Catalytic Converter System

Component Location Index CATALYTIC CONVERTER Removal/Installation POWERTRAIN CONTROL MODULE (PCM) General Troubleshooting information Replacement DTC Troubleshooting DTC P0420: Catalyst System Efficiency Below Threshold NOTE: Before you troubleshoot, record all f

 Nothing Happens or the Starter Motor Operates Very Slowly

When you turn the ignition switch to the START (III) position, you do not hear the normal noise of the engine trying to start. You may hear a clicking sound, a series of clicks, or nothing at all. Check these things: Check the transmission interlock. The transmission must be in Park o

© 2016-2025 Copyright www.hcrv.net