Honda CR-V: Reporting Safety Defects (U.S. Vehicles)

Honda CR-V (2006–2011) Owner's Manual / Warranty and Customer Relations / Reporting Safety Defects (U.S. Vehicles)

If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) in addition to notifying American Honda Motor Co., Inc.

If NHTSA receives similar complaints, it may open an investigation, and if it finds that a safety defect exists in a group of vehicles, it may order a recall and remedy campaign.

However, NHTSA cannot become involved in individual problems between you, your dealer, or American Honda Motor Co., Inc.

To contact NHTSA, you may call the Vehicle Safety Hotline toll-free at 1-888-327-4236БЮ (TTY: 1-800-424-9153); go to http://www.saf ercar.gov; or write to:
Administrator, NHTSA, 1200 New Jersey Avenue, SE., Washington, DC 20590.

You can also obtain other information about motor vehicle safety from http://www.saf ercar.gov.

READ NEXT:

 AuthorizedManuals

Purchasing Factory Authorized Manuals (U.S. only) The publications shown below can be purchased from Helm Incorporated. You can order by phone or online: - Call Helm Inc. at 1-800-782-4356 (credit

 Honda CR-V (2006–2011) Service Manual

 Introduction

How to Use This Manual This manual is divided into multiple sections. The first page of each section is marked with a black tab that lines up with its corresponding thumb index tab on this page and th

SEE MORE:

 Front Bumper

Front Bumper Removal/Installation NOTE: Have an assistant help you when removing and installing the front bumper. Take care not to scratch the front bumper and body. Put on gloves to protect your hands. 1. Remove the front bulkhead cover. 2. Remove the bolts (A) and clips (B, C) securing the

 Upper Arm Replacement

1. Raise the rear of the vehicle, and support it with safety stands in the proper locations. 2. Remove the rear wheel. 3. Place a floor jack under the trailing arm, and support the suspension. 4. Remove the wheel sensor harness bracket (A) from the upper arm (B). 5. Remove the flange bolts (A),

© 2016-2025 Copyright www.hcrv.net