Honda CR-V: Fan, Fan Motor, Shroud Removal and Installation

Honda CR-V (2006–2011) Service Manual / Engine Cooling / Cooling System / Fan, Fan Motor, Shroud Removal and Installation

Removal

1. Remove the hood support rod, then use it as shown to prop the hood in the wide-open position.

Honda CR-V. Cooling System

2. Remove the bulkhead cover.

3. Disconnect the fan motor connectors (A) and hood switch connector (B), then remove the harness clips (C).

Honda CR-V. Cooling System

4. Remove the radiator upper brackets (A), then remove the front bulkhead (B).

Honda CR-V. Cooling System

5. Remove the condenser fan shroud assembly (A), then remove the radiator fan shroud assembly (B) from condenser fan shroud side.

Honda CR-V. Cooling System

6. Disassemble the fan shrouds.

Honda CR-V. Cooling System

Installation

1. Assemble the fan shrouds.

Honda CR-V. Cooling System

2. Install the radiator fan shroud assembly (A), then install the condenser fan shroud assembly (B).

Honda CR-V. Cooling System

3. Install the front bulkhead (A), then install the radiator upper brackets (B).

Honda CR-V. Cooling System

4. Apply body paint to the bulkhead mounting bolts.

5. Connect the fan motor connectors (A) and hood switch connector (B), then install the harness clips (C).

Honda CR-V. Cooling System

6. Remove the bulkhead cover.

READ NEXT:

 Radiator Replacement

For Japan-produced Model 1. Drain the engine coolant. 2. Remove the hood support rod, then use it as shown to prop the hood in the wide-open position. 3. Remove the bulkhead cover. 4. Remove the co

 Fan Controls

Component Location Index RADIATOR FAN RELAY A/C CONDENSER FAN RELAY FAN CONTROL RELAY A/C CONDENSER FAN ASSEMBLY RADIATOR FAN ASSEMBLY ENGINE COOLANT TEMPERATURE (ECT) SENSOR 1 E

 Fuel and Emissions

SEE MORE:

 DTC P0731: Problem in 1st Clutch and 1st Clutch Hydraulic Circuit

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. 1. Warm up the engine to normal operating temperature (the radiator fan comes on). 2. Make sure that the transmission is filled to the proper level, and check for fluid

 Installing a Child Seat with a Lap/Shoulder Belt

When not using the LATCH system, all child seats must be secured to the vehicle with the lap part of a lap/ shoulder belt. In addition, the lap/shoulder belts in all seating positions except the driver’s have a lockable retractor that must be activated to secure a child seat. If yo

© 2016-2025 Copyright www.hcrv.net