Honda CR-V: ThreeWay Catalytic Converter

The three way catalytic converter contains precious metals that serve as catalysts, promoting chemical reactions to convert the exhaust gasses without affecting the metals.

The catalytic converter is referred to as a three-way catalyst, since it acts on HC, CO, and NOx. A replacement unit must be an original Honda part or its equivalent.

The three way catalytic converter must operate at a high temperature for the chemical reactions to take place. It can set on fire any combustible materials that come near it. Park your vehicle away from high grass, dry leaves, or other flammables.

A defective three way catalytic

A defective three way catalytic converter contributes to air pollution, and can impair your engine’s performance.

Follow these guidelines to protect your vehicle’s three way catalytic converter.

Always use unleaded gasoline.

Even a small amount of leaded gasoline can contaminate the catalyst metals, making the three way catalytic converter ineffective.

Keep the engine well maintained.

Have your vehicle diagnosed and repaired if it is misfiring, backfiring, stalling, or otherwise not running properly.

READ NEXT:

 Emissions Testing

Testing of Readiness Codes If you take your vehicle for an emissions test shortly after the battery has been disconnected or gone dead, it may not pass the test. This is because of certain ‘

 Warranty and Customer Relations

 Customer Service Information

Honda dealership personnel are trained professionals. They should be able to answer all your questions. If you encounter a problem that your dealership does not solve to your satisfaction, pl

SEE MORE:

 DTC Troubleshooting

DTC B1000: Communication Bus Line Error (Bus-off) 1. Clear the DTCs with the HDS. 2. Turn the ignition switch OFF, and then back ON (II). 3. Wait for 6 seconds or more. 4. Check for DTCs with the HDS. Is DTCs B1000 and/or B1008 and B1011 indicated? YES-Go to step 5. NO-Intermittent failure, the

 Removing a Disc

To remove a disc from the audio unit, fold back the screen by pressing the OPEN button. Press the disc eject button ( ) to remove the disc. If you eject the disc, but do not remove it from the slot, the system will automatically reload it after 10 seconds and put it in pause mode.

© 2016-2025 Copyright www.hcrv.net