Honda CR-V: WindshieldWashers

Pull the wiper control lever toward you, and hold it. The washers spray until you release the lever. The wipers run at low speed, then complete one more sweep after you release the lever.

READ NEXT:

 Rear Window Wiper and Washer

1. OFF When you turn the wiper switch to the ‘‘OFF’’ position, the wiper will return to its parked position. 2. Rotate the switch clockwise to turn the rear window wiper ON. The

 Turn Signal and Headlights

1. Turn Signal 2. OFF 3. Parking and interior lights 4. AUTO 5. Headlights on 6. High Beams 7. Flash high beams *: If equipped Turn Signal - Push down on the lever to signal a left turn

 Daytime Running Lights

With the headlight switch in the off or position, the high beam headlights and the high beam indicator come on with reduced brightness when you turn the ignition switch to the ON (II)

SEE MORE:

 Starting System

Component Location Index STARTER CUT RELAY UNDER-DASH FUSE/RELAY BOX STARTER Starter Circuit Troubleshooting Performance Test Removal and Installation Overhaul TRANSMISSION RANGE SWITCH Test Replacement Symptom Troubleshooting Index Engine

 DTC 91: VSA System

1. Check the brake system for leaks or mechanical problems. Is the brake system OK? (No brake fluid leakage, no air trapped in the brake system, no brake pads worn out.) YES-Go to step 2. NO-Repair the brake system, then recheck. 2. Turn the ignition switch ON (II). 3. Clear the DTC with the HDS

© 2016-2025 Copyright www.hcrv.net