Honda CR-V: MICU Input Test

1. Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A, and check the No.8 (10 A), No. 10 (7.5 A), and No. 38 (30 A) fuses in the under-dash fuse/relay box.

2. Disconnect under-dash fuse/relay box connectors E, F, S, and T.

NOTE: All connector views are wire side of female terminals.

Honda CR-V. Wipers/Washers

3. Inspect the connector and socket terminals to be sure they are all making good contact.

4. With the connectors still disconnected, make these input tests at the appropriate connector.

Honda CR-V. Wipers/Washers

5. Reconnect the connectors to the under-dash fuse/relay box, and make these input tests at the connectors.

Honda CR-V. Wipers/Washers

READ NEXT:

 Wiper/Washer Switch Test/Replacement

1. Remove the steering column covers. 2. Disconnect the dashboard wire harness 8P connector (A) from the wiper/washer switch (B). 3. Remove the two screws, then slide out the wiper/ washer switch.

 Gauges

Component Location Index GAUGE CONTROL MODULE Self-diagnostic Function Input Test Rewriting the ODO Data and Transferring Smart Maintenance on a New Gauge Control Module Replacement Out

 Reminder Systems

Component Location Index GAUGE CONTROL MODULE MICU Circuit Diagram Control Unit Input Test NOTE: Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A. MICU 1. Turn the ignition s

SEE MORE:

 To Stop Playing a Disc

Press the AM, FM, AUX button, or CD/AUX, XM button to switch to the radio or satellite radio (U.S. models), while a disc is playing. Press the CD button again to play the disc. If you turn the system off while a disc is playing, either with the ( ) button or by turning off the ignit

 Adjust the Front Seats

Adjust the driver’s seat as far to the rear as possible while allowing you to maintain full control of the vehicle. Have a front passenger adjust their seat as far to the rear as possible. If you sit too close to the steering wheel or dashboard, you can be seriously injured by an i

© 2016-2025 Copyright www.hcrv.net