Honda CR-V: Front Passenger's Airbag Replacement

Removal

1. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work.

2. Remove the passenger's vent panel.

3. Remove the dashboard center upper panel.

4. Remove the access panel (see step 5).

5. Detach the hook of the glove box damper and release the glove box stop on each side from the dashboard by pushing them inside (see step 1), then disconnect the front passenger's airbag 4P connector (A) from the dashboard wire harness.

Honda CR-V. SRS (Supplemental Restraint System)

6. Remove the three mounting nuts (A) from the bracket. Using only your hands, first lift the front edge of the airbag, then lift the left side, then lift the right side, and remove the front passenger's airbag (B) from the dashboard.

NOTE: The airbag lid has pawls (C) on each side which attach it to the dashboard.

Honda CR-V. SRS (Supplemental Restraint System)

Installation

1. Place the new front passenger's airbag (A) into the dashboard. Tighten the front passenger's airbag mounting nuts (B).

Honda CR-V. SRS (Supplemental Restraint System)

2. Connect the front passenger's airbag 4P connector (A) to dashboard wire harness, then reinstall the glove box.

Honda CR-V. SRS (Supplemental Restraint System)

3. Install the access panel (see step 5).

4. Install the dashboard center upper panel.

5. Install the passenger's vent panel.

6. Reconnect the negative cable to the battery.

7. After installing the airbag, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.

READ NEXT:

 Side Airbag Replacement

NOTE: Review the seat replacement procedure before doing repairs or service. Removal 1. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work. 2. Disconnec

 Airbag and Tensioner Disposal

Special Tools Required Deployment tool 07HAZ-SG00500 Before scrapping any airbags, side airbags, side curtain airbags, seat belt tensioners; or lap belt tensioner (including those in a whole vehicle t

 Cable Reel Replacement

Removal 1. Make sure the front wheels are aligned straight ahead. 2. Disconnect the negative cable from the battery, and wait at least 3 minutes. 3. Remove the driver's airbag. 4. Disconnect the co

SEE MORE:

 Introduction

How to Use This Manual This manual is divided into multiple sections. The first page of each section is marked with a black tab that lines up with its corresponding thumb index tab on this page and the back cover. You can quickly find the first page of each section without looking through a full ta

 Text Data Display Function

Each time you press the TITLE button, the display shows you the text, if the disc was recorded with text data. You can see the album, artist, and track name in the display. If a disc is recorded in MP3 or WMA, you can see the folder and file name, and the artist, album, and track tag.

© 2016-2025 Copyright www.hcrv.net