Honda CR-V: Break-in Period

Help assure your vehicle’s future reliability and performance by paying extra attention to how you drive during the first 600 miles (1,000 km).

During this period:

Avoid full-throttle starts and rapid acceleration.

Do not change the oil until the scheduled maintenance time.

Avoid hard braking for the first 200 miles (300 km).

Do not tow a trailer.

You should also follow these recommendations with an overhauled or exchanged engine, or when the brakes are replaced.

READ NEXT:

 Fuel Recommendation

Your vehicle is designed to operate on unleaded gasoline with a pump octane number of 87 or higher. Use of a lower octane gasoline can cause a persistent, heavy metallic rapping noise that c

 Service Station Procedures

 Refueling

1. Park with the driver’s side closest to the service station pump. 2. Open the fuel fill door by pulling on the handle located under the lower left corner of the dashboard. 3. Remove th

SEE MORE:

 PCM Replacement

NOTE: Make sure the HDS is loaded with the latest software version. If you are replacing the PCM after substituting a known-good PCM, reinstall the original PCM, then do this procedure. During the procedure, is any READ DATA, WRITE DATA, or other data checks fail, note the failure, then con

 Wiper/Washer Switch Test/Replacement

1. Remove the steering column covers. 2. Disconnect the dashboard wire harness 8P connector (A) from the wiper/washer switch (B). 3. Remove the two screws, then slide out the wiper/ washer switch. 4. Inspect the connector terminals to be sure they are all making good contact. If the terminals a

© 2016-2025 Copyright www.hcrv.net