Honda CR-V: Outside Temperature Indicator
If equipped
This indicator displays the outside temperature in Fahrenheit (U.S.
models) or Celsius (Canadian models).
The temperature sensor is in the front bumper. Therefore, the temperature reading can be affected by heat reflection from the road surface, engine heat, and the exhaust from surrounding traffic.
This can cause an incorrect temperature reading when your speed is under 19 mph (30 km/h).
The sensor delays the display update until it reaches the correct outside temperature. This may take several minutes.
If the outside temperature is incorrectly displayed, you can adjust it up to +/-5°F in U.S. models (+/- 3°C in Canadian models) warmer or cooler.
NOTE: The temperature must be stabilized before doing this procedure.
To adjust the outside temperature display, press and hold the select/ reset knob for 10 seconds. The display changes as shown above.
Select the outside temperature indicator by turning the select/reset knob. The display begins to blink.
Push the same knob to enter this setting, then turn it to adjust the temperature. The following sequence will appear for each: 0, 1, 2, 3, 4, 5, -5, -4, -3, -2, -1, 0 (U.S.) or 0, 1, 2, 3, -3, -2, -1, 0 (Canada).
When it reaches the desired value, push the select/reset knob to enter the setting. You should see the new outside temperature displayed.
In certain weather conditions, temperature readings near freezing (32°F, 0°C) could mean that ice is forming on the road surface.
READ NEXT:
Check Fuel Cap Message
If your fuel fill cap is loose or
missing, a ‘‘CHECK FUEL CAP’’
message appears on the information
display after you start the engine.
Maintenance Minder
The information display in the
instrument panel shows you the
engine oil life and maintenance
service items when the ignition
switch is in the ON (II) position. This
information helps to kee
Controls Near the Steering Wheel
Controls Near the Steering Wheel
SEE MORE:
A/T Differential
Component Location Index
4WD
2WD
Backlash Inspection
NOTE: The illustration shows the 4WD model; 2WD is
similar.
1. Install the drive shaft and intermediate shaft into
the differential assembly.
2. Secure the driveshaft (A) in a bench vise (B) with
soft jaws (C). To prevent damage to the drivesh
Upper/Lower Front Grille Replacement
Upper Front Grille Replacement
NOTE: Take care not to scratch the bumper and grille.
1. Remove the front bumper.
2. Remove the clips from the back of the front grille
and release the hooks (A), then release the hooks
(B) and remove the upper front grille (C) from the
lower front grille (D).
3. Re
