Honda CR-V: Dual Temperature Control

EX-L model only

EX-L model only

The temperatures of the driver’s side and the front passenger’s side can be controlled independently when the indicator in the DUAL button is on.

To adjust the driver’s side, turn the driver’s side temperature control dial on the climate control panel. To adjust the passenger’s side, turn the passenger’s side temperature control dial.

Temperature Control

Push AUTO or temperatures appear in the display.. The selected temperatures appear in the display.

When the indicator in the DUAL button is off, you can adjust both sides to the same temperature by adjusting the driver’s temperature control dial.

To set the driver’s side temperature

To set the driver’s side temperature to a different value than the passenger’s side, press the DUAL button, then turn the temperature control dial on the control panel. To set the passenger’s side to a different value than the driver’s side, turn the passenger’s side temperature control dial. You can adjust the passenger’s side without pressing the DUAL button first.

When you set the temperature to its lower limit or its upper limit, it will be displayed as ‘‘Lo’’ or ‘‘Hi’’.

READ NEXT:

 Climate Control Sensors

Sunlight and Temperature Sensors The climate control systemhas two sensors: a sunlight sensor on top of the dashboard, and a temperature and humidity sensor next to the steering column. D

 Audio System

An audio system is standard on all models. Read the appropriate pages (as shown below) to use your vehicle’s audio system. Audio System

 Playing the AM/FM Radio (LX model)

Playing the AM/FM Radio (LX model)

SEE MORE:

 Protecting Infants

Child Seat Type An infant must be properly restrained in a rear-facing, reclining child seat until the child reaches the seat maker’s weight or height limit for the seat, and the child is at least one year old. Only a rear-facing child seat provides proper support for a baby’s

 Cam Chain Inspection

1. Remove the front wheels. 2. Remove the splash shield (see step 21). 3. Remove the drive belt. 4. Remove the cylinder head cover. 5. Set the No.1 piston at top dead center (TDC). The punch mark on the variable valve timing control (VTC) actuator and the punch mark on the exhaust camshaft sproc

© 2016-2025 Copyright www.hcrv.net