Honda CR-V: Fan Controls

Component Location Index

Honda CR-V. Fan Controls

Symptom Troubleshooting Index

Honda CR-V. Fan Controls

Circuit Diagram

Honda CR-V. Fan Controls

Radiator Fan High Speed Circuit Troubleshooting

1. Remove the fan control relay from the under-hood fuse/relay box, and test it.

Is the relay OK?

YES-Go to step 2.

NO-Replace the fan control relay.

2. Measure the voltage between the fan control relay 5P socket terminal No. 5 and body ground.

Is there battery voltage? YES-Go to step 3.

NO-Replace the under-hood fuse/relay box.

3. Check for continuity between the fan control relay 5P socket terminal No.2 and body ground.

Is there continuity? YES-Replace the under-hood fuse/relay box.

NO-Repair open in the wire between the fan control relay 5P socket terminal No.2 and body ground. If the wire is OK, check for poor ground at G301.

READ NEXT:

 Fuel and Emissions

 Fuel and Emissions Systems

Special Tools Fuel Sender Wrench Fuel Pressure Gauge Attachment Set Vacuum/Pressure Gauge, 0-4 in.Hg Pressure Gauge Adapter Oil Pressure Hose A/T Pressure Hose A/T Low Pressure

 General Troubleshooting Information

Intermittent Failures The term "intermittent failure" means a system may have had a failure, but it checks OK now. If the malfunction indicator lamp (MIL) on the dash does not come on, check for poor

SEE MORE:

 Door Lock

Door Lock Actuator Test Driver's Door and Left Rear Door 1. Remove the door panel. Front Rear 2. Disconnect the 10P connector (A) from the actuator (B). NOTE: The illustration shows the driver's door. 3. Check the actuator operation by connecting power and ground according to the table. To

 Maintenance

Lubricants and Fluids For details of lubrication points and type of lubricants to be applied, refer to the illustrated index and various work procedures (such as Assembly/Reassembly, Replacement, Overhaul, Installation, etc.) contained in each section. API CERTIFICATION SEAL Recommended Engine O

© 2016-2025 Copyright www.hcrv.net