Honda CR-V (2006–2011) Service Manual

Honda CR-V (2006–2011) Service Manual

READ NEXT:

 Introduction

How to Use This Manual This manual is divided into multiple sections. The first page of each section is marked with a black tab that lines up with its corresponding thumb index tab on this page and th

 General Information

Chassis and Paint Codes Vehicle Identification Number Manufacturer, Make and Type of Vehicle 5J6: Honda of America Mfg., Inc., U.S.A. Honda Multipurpose passenger vehicle JHL: Honda Motor Co

 Maintenance

Lubricants and Fluids For details of lubrication points and type of lubricants to be applied, refer to the illustrated index and various work procedures (such as Assembly/Reassembly, Replacement, Ove

SEE MORE:

 Boot Band Installation

Special Tools Required Boot band tool, KD-3191 or equivalent, commercially available Boot band pliers, Kent-Moore J-35910 or equivalent, commercially available Double Loop Type 1. Fit the boot ends onto the driveshaft and the inboard joint, then install the new double loop band (A) onto the boot. N

 Recirculation Control Motor Circuit Troubleshooting

1. Check the No. 36 (10 A) fuse in the under-dash fuse/ relay box. Is the fuse OK? YES-Go to step 2. NO-Replace the fuse, and recheck. If the fuse blows again, check for a short in the No. 36 (10 A) fuse circuit. 2. Disconnect the recirculation control motor 7P connector. 3. Turn the ignition s

© 2016-2025 Copyright www.hcrv.net