Honda CR-V: Avoiding Obstacles

Debris in the road can damage your suspension or other components.

Because your vehicle has a high center of gravity, driving over a large obstacle, or allowing a wheel to drop into a deep hole can cause your vehicle to tip or roll over.

READ NEXT:

 Driving on Slopes

If you can’t clearly see all conditions or obstacles on a slope, walk the slope before you drive on it. If you have any doubt whether or not you can safely drive on the slope, don’t do i

 Crossing a Stream

Avoid driving through deep water. If you encounter water in your route (a small stream or large puddle, for example), evaluate it carefully before going ahead. Make sure it is shallow, flowi

 If You Get Stuck

Avoid driving on soft sand, deep mud, or other surfaces where you could get stuck. If you do happen to get stuck because of inclement weather or other conditions, choose a safe and appropria

SEE MORE:

 Changing a Tire with TPMS

If you have a flat tire, the low tire pressure indicator will come on. Replace the flat tire with the compact spare tire. Each wheel (except the compact spare tire wheel) is equippedwith a tire pressure sensor. You must use TPMS specific wheels. It is recommended that you always have

 DTC P0107: Manifold Absolute Pressure (MAP) Sensor Circuit Low Voltage Input

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. 1. Clear the DTC with the HDS. 2. Turn the ignition switch OFF, then turn it ON (II) again. 3. Check whether DTC P0107 is indicated in the DTCs/ Freeze Data in PGM-FI M

© 2016-2025 Copyright www.hcrv.net