Honda CR-V: Transaxle

READ NEXT:

 Automatic Transmission

Special Tools 07HAE-PL50101 may also be used to substitute one of 07LAE-PX40100. Mainshaft Holder Attachment, 78 x 90 mm Clutch Spring Compressor Bolt Assembly Holder Handle Oil Seal Driver At

 General Troubleshooting Information

How to Check for DTCs with the Honda Diagnostic System (HDS) When the powertrain control module (PCM) senses an abnormality in the input or output system, the D indicator (A) in the gauge control modu

 System Description

SEE MORE:

 Replacement Parts

The emissions control systems are designed and certified to work together in reducing emissions to levels that comply with the Clean Air Act. To make sure the emissions remain low, you should use only new Honda replacement parts or their equivalent for repairs. Using lower quality pa

 DTC 86: F-CAN Communication

1. Turn the ignition switch ON (II). 2. Clear the DTC with the HDS. 3. Turn the ignition switch OFF. 4. Start the engine. 5. Wait at least 5 seconds. 6. Check for DTCs with the HDS. Is DTC 86 indicated? YES-Go to step 7. NO-Intermittent failure, the system is OK at this time. Check for a loos

© 2016-2025 Copyright www.hcrv.net