Honda CR-V: To Stop Playing Your iPod
To play the radio when an iPod is playing, press the FM, AM or XM button. If a disc is in the audio unit, press the CD/AUX or CD button to play the disc.
Disconnecting an iPod
You can disconnect the iPod at any time when you see the ‘‘OK to disconnect’’ message* in the iPod display. Always make sure you see the ‘‘OK to disconnect’’ message in the iPod display before you disconnect it. Make sure to follow the iPod’s instructions on how to disconnect the dock connector from the USB adapter cable.
*: The displayed message may vary on models or versions. On some models, there is no message to disconnect.
If you reconnect the same iPod, the system may begin playing where it left off, depending on what mode the iPod is in when it is reconnected.
When you disconnect the iPod while it is playing, the display shows ‘‘USB NO DATA.’’
READ NEXT:
iPod Error Messages
If you see an error message on the
audio display while playing an iPod,
find the solution in the chart to the
right. If you cannot clear the error
message, take your vehicle to your
dealer.
Playing a USB Flash Memory Device (Canadian EX model and EX-L model without
navigation system)
Playing a USB Flash Memory Device (Canadian EX model and EX-L model without
navigation system)
To Play a USB Flash Memory Device
This audio system can operate the
audio files on a USB flash memory
device with the same controls used
for the in-dash disc changer. To play
a USB flash memory device, connect
it to the USB
SEE MORE:
Cylinder Head Installation
1. Install a new coolant separator in the engine block
whenever the engine block is replaced.
2. Clean the cylinder head and block surface.
3. Install the new cylinder head gasket (A) and dowel
pins (B) on the engine block. Always use a new
cylinder head gasket.
Set the crankshaft to top dead cen
System Description
VSA Modulator-control Unit Inputs and Outputs for 46P Connector
System Outline
This system is composed of the VSA modulator-control unit, the wheel sensors,
the steering angle sensor, and the
yaw rate-lateral acceleration sensor, and the system indicators in the gauge
control module. The VSA mo
