Honda CR-V manuals

Honda CR-V: Windshield Wiper

Honda CR-V (2006–2011) Owner's Manual / Instruments and Controls / Windshield Wipers and Washers / Windshield Wiper

1. MIST

1. MIST
2. OFF
3. INT Intermittent
4. LO Low speed
5. HI High speed
6. Windshield washers

Push the right lever up or down to select a position.

MIST - The wipers run at high speed until you release the lever.

OFF - The wipers are not activated.

INT - The wipers operate every few seconds. At low speed and high speed, the wipers run continuously.

On all models except LX

Vary the delay by turning the adjustment ring. If you turn it to the shortest delay (wipers change to low speed position), the wipers change to low speed operation when the vehicle speed exceeds 12 mph (20 km/h).

The length of the wiper interval is varied automatically according to the vehicle’s speed.

LO - The wipers run at low speed.

HI - The wipers run at high speed.

READ NEXT:

 WindshieldWashers

Pull the wiper control lever toward you, and hold it. The washers spray until you release the lever. The wipers run at low speed, then complete one more sweep after you release the lever.

 Rear Window Wiper and Washer

1. OFF When you turn the wiper switch to the ‘‘OFF’’ position, the wiper will return to its parked position. 2. Rotate the switch clockwise to turn the rear window wiper ON. The

 Turn Signal and Headlights

1. Turn Signal 2. OFF 3. Parking and interior lights 4. AUTO 5. Headlights on 6. High Beams 7. Flash high beams *: If equipped Turn Signal - Push down on the lever to signal a left turn

SEE MORE:

 Ignition Switch

The ignition switch has four positions: LOCK (0), ACCESSORY (I), ON (II), and START (III). LOCK (0) - You can insert or remove the key only in this position. To turn the key, the shift lever must be in Park, and you must push the key in slightly. If the front wheels are turned, the

 Instrument Panel Brightness

You can change the instrument panel brightness only when the light switch is on. Turn the knob on the lower part of the instrument panel to adjust the brightness. You will hear a beep when maximum or minimum brightness is reached. To reduce glare at night, the instrument panel

© 2016-2025 Copyright www.hcrv.net