Honda CR-V: Component Replacement/Inspection After Deployment

Honda CR-V (2006–2011) Service Manual / Restraints / SRS (Supplemental Restraint System) / Component Replacement/Inspection After Deployment

NOTE:

After a collision where the seat belt tensioners deployed, replace these items:"

After a collision where the front airbag(s) deployed, replace these items:

After a collision where the side airbag(s) deployed, replace these items:

After a collision1where the side curtain airbag(s).

deployed, replace these items:

After a moderate to severe side or rear collision, inspect for any damage on the side curtain airbag or other related components. Replace components as needed.

A-pillar trim

Honda CR-V. SRS (Supplemental Restraint System)

B-pillar trim

Honda CR-V. SRS (Supplemental Restraint System)

C-Pillar trim

Honda CR-V. SRS (Supplemental Restraint System)

During the repair process, inspect these areas:

After the vehicle is completely repaired, turn the ignition switch ON (II). If the SRS indicator comes on for about 6 seconds and then goes off, the SRS is OK. If the indicator does not function properly, use the HDS SRS Menu Method to read the DTC. If you cannot retrieve a code, go to SRS Symptom Troubleshooting.

Checking and Adjusting the Headliner/Piliar Trim Overlap

To prevent the side curtain airbag from deploying and damaging the pillar trim, the overlap between the headliner and pillar trim must be less then 0.3 in.

(8 mm). To check the overlap, do this: 1. Install the headliner (A) and the pillar trim (B).

Honda CR-V. SRS (Supplemental Restraint System)

2. Using masking tape on the headliner, mark the upper edge of each pillar trim.

Honda CR-V. SRS (Supplemental Restraint System)

3. Remove the pillar trim, and measure the headliner overlap.

Honda CR-V. SRS (Supplemental Restraint System)

4. Carefully trim the headliner with a utility knife, reducing the overlap to less than 0.3 in. (8 mm).

Honda CR-V. SRS (Supplemental Restraint System)

5. Remove the tape, and install the pillar trim.

READ NEXT:

 Driver's Airbag Replacement

Removal 1. Disconnect the negative cable from the battery and wait at least 3 minutes before beginning work. 2. Remove the access panel (A) from the steering wheel, then disconnect the driver's airba

 Front Passenger's Airbag Replacement

Removal 1. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work. 2. Remove the passenger's vent panel. 3. Remove the dashboard center upper panel. 4. Re

 Side Airbag Replacement

NOTE: Review the seat replacement procedure before doing repairs or service. Removal 1. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work. 2. Disconnec

SEE MORE:

 Torque Converter Housing

Mainshaft Bearing and Oil Seal Replacement Special Tools Required Adjustable bearing puller, 25-40 mm 07736-A01000B or 07736-A01000A Attachment, 62 x 68 mm 07746-0010500 Attachment, 72 x 75 mm 07746-0010600 Driver 07749-0010000 1. Remove the mainshaft bearing and oil seal using the adjustabl

 Nothing Happens or the Starter Motor Operates Very Slowly

When you turn the ignition switch to the START (III) position, you do not hear the normal noise of the engine trying to start. You may hear a clicking sound, a series of clicks, or nothing at all. Check these things: Check the transmission interlock. The transmission must be in Park o

© 2016-2025 Copyright www.hcrv.net