Honda CR-V: Seat Heaters
Component Location Index

- DRIVER'S SEAT
HEATER RELAY (HIGH)
- DRIVER'S SEAT
HEATER RELAY (LOW)
- DRIVER'S SEAT CUSHION HEATER
- DRIVER'S SEAT-BACK HEATER
- FRONT PASSENGER'S
SEAT-BACK HEATER
- FRONT PASSENGER'S
SEAT CUSHION HEATER
- FRONT PASSENGER'S SEAT
HEATER RELAY (HIGH)
- FRONT PASSENGER'S SEAT
HEATER RELAY (LOW)

- DRIVER'S SEAT HEATER SWITCH
- FRONT PASSENGER'S
SEAT HEATER SWITCH
Circuit Diagram


Seat Heater Test
1. Remove the driver's or front passenger's seat.
2. Disconnect the 3P (A) and 2P (B) connectors from
the seat heater.
Driver's Seat

Front Passenger's Seat

3. Check for continuity between the seat heater
connector B (2P) No.1 and No.2 terminals. There
should be continuity.
4. Reconnect the seat heater connector B (2P) to the
seat-back heater.
5. Check for continuity between the seat heater
connector A (3P) No.1 and No.2 terminals, No.2
and No.3 terminals, and No.1 and No.3 terminals.
There should be continuity.
6. If the continuity is not as specified, replace the
appropriate seat heater.
Switch Test/Replacement
1. Remove the shift lever panel.
2. Disconnect the 6P (or 7P) connector from the seat
heater switch (A), then remove the switch.
* : Front passenger's

3. Check for continuity between the terminals in each
switch position according to the table.

: Front
passenger's seat heater switch
4. If the continuity is not as specified, replace the
switch.
READ NEXT:
Component Location Index
UNDER-DASH FUSE/
RELAY BOX
UNDER-HOOD FUSE/RELAY BOX
REAR WINDOW DEFOGGER RELAY
HVAC CONTROL UNIT
REAR WINDOW DEFOGGER SWITCH/
MIRROR DEFOGGER SWITCH
REAR WINDOW DEF
Component Location Index
IMMOBILIZER INDICATOR
IMMOBILIZER-KEYLESS CONTROL UNIT (Built-in receiver)
UNDER-DASH
FUSE/RELAY BOX
IMOES UNIT
(Built into the MICU)
PCM
IGNITION KEY
TRANSPONDE
SEE MORE:
Your vehicle’s audio system will
disable itself if it is disconnected
from electrical power for any reason.
To make it work again, you must
enter a specific code using the preset
buttons (icon on vehicle’s with
navigation system). Because there
are hundreds of number
combinations
Special Tools Required
SRS inflator simulator 07SAZ-TB4011A
SRS simulator lead K 070AZ-SNAA200
NOTE: Before doing this troubleshooting procedure,
review SRS Precautions and Procedures.
1. Erase the DTC memory.
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for ab
© 2016-2025 Copyright www.hcrv.net
