Honda CR-V: TripMeter

This meter shows the number of miles (U.S.) or kilometers (Canada) driven since you last reset it.

There are two trip meters: Trip A and Trip B. Switch between these displays by pressing the select/reset knob repeatedly.

Each trip meter works independently, so you can keep track of two different distances.

When you turn the ignition switch to the ON (II) position, the last selection is displayed.

To reset a trip meter, display it, and then press and hold the select/reset knob until the number resets to ‘‘0.0’’.

READ NEXT:

 Instant Fuel Economy

This display shows the instant fuel economy you are getting. It shows the number of mpg (U.S.) or l/100 km (Canada).

 Average Fuel Economy

When either of the trip meters (trip A or B) is displayed, your vehicle’s average fuel economy since you last reset that tripmeter can be shown on the information display (mpg on U.S. mode

 Range (Estimated Distance)

This display shows the estimated distance you can travel on the fuel remaining in the tank. This distance is estimated from the fuel economy you have achieved over the last few miles (kilomet

SEE MORE:

 Charging System Indicator Circuit Troubleshooting

1. Turn the ignition switch ON (II). Does the charging system indicator come on? YES-Go to step 2. NO-Go to step 14. 2. Start the engine. Hold the engine speed at 2,000 rpm for 1 minute. Does the charging system indicator go off? YES-Charging system indicator circuit is OK. Go to the alternator

 DTC 33-9x ("x" can be 0 thru 9 or A thru F): Short to Ground in Left Side Curtain Airbag Inflator

Special Tools Required SRS inflator simulator 07SAZ-TB4011A SRS simulator lead L 070AZ-SNAA300 NOTE: Before doing this troubleshooting procedure, review SRS Precautions and Procedures. 1. Erase the DTC memory. 2. Turn the ignition switch ON (II), and check that the SRS indicator comes on for a

© 2016-2025 Copyright www.hcrv.net