Honda CR-V: Accelerating and Braking

For better traction on all surfaces, accelerate slowly and gradually build up speed. If you try to start too fast on wet soil, mud, snow, or ice, you might not have enough traction to get underway, and you may dig yourself a hole. Starting with the shift lever in second (2) gear will help you have a smoother start on snow or ice.

Keep in mind that you will usually need more time and distance to brake to a stop on unpaved surfaces.

Avoid hard braking. Do not ‘‘pump’’ the brakes; let the anti-lock braking system pump them for you.

READ NEXT:

 Avoiding Obstacles

Debris in the road can damage your suspension or other components. Because your vehicle has a high center of gravity, driving over a large obstacle, or allowing a wheel to drop into a deep ho

 Driving on Slopes

If you can’t clearly see all conditions or obstacles on a slope, walk the slope before you drive on it. If you have any doubt whether or not you can safely drive on the slope, don’t do i

 Crossing a Stream

Avoid driving through deep water. If you encounter water in your route (a small stream or large puddle, for example), evaluate it carefully before going ahead. Make sure it is shallow, flowi

SEE MORE:

 DLC Circuit Troubleshooting

NOTE: Make sure the HDS and the DLC cable of the HDS is not defective. 1. Turn the ignition switch OFF. 2. Connect the HDS to the DLC. NOTE: Make sure the HDS is properly connected to the DLC. 3. Turn the ignition switch ON (II). and read the HDS. Does the HDS identify the vehicle? YES-Go to ste

 Intermediate Shaft

Intermediate Shaft Removal 1. Drain the automatic transmission fluid. Reinstall the drain plug with a new washer. 2. Remove the right driveshaft. 3. Remove the flange bolt (A) and two dowel bolts (B). 4. Remove the intermediate shaft (A) from the differential. Hold the intermediate shaft horizon

© 2016-2025 Copyright www.hcrv.net