Honda CR-V: WindshieldWashers

Pull the wiper control lever toward you, and hold it. The washers spray until you release the lever. The wipers run at low speed, then complete one more sweep after you release the lever.

READ NEXT:

 Rear Window Wiper and Washer

1. OFF When you turn the wiper switch to the ‘‘OFF’’ position, the wiper will return to its parked position. 2. Rotate the switch clockwise to turn the rear window wiper ON. The

 Turn Signal and Headlights

1. Turn Signal 2. OFF 3. Parking and interior lights 4. AUTO 5. Headlights on 6. High Beams 7. Flash high beams *: If equipped Turn Signal - Push down on the lever to signal a left turn

 Daytime Running Lights

With the headlight switch in the off or position, the high beam headlights and the high beam indicator come on with reduced brightness when you turn the ignition switch to the ON (II)

SEE MORE:

 VTEC/VTC

Component Location Index ROCKER ARM OIL CONTROL VALVE Removal/Installation ROCKER ARM OIL PRESSURE SWITCH Removal/Installation CAMSHAFT POSITION (CMP) SENSOR A (INTAKE) Replacement POWERTRAIN CONTROL MODULE (PCM) Gene

 Symptom Troubleshooting

Low pressure indicator does not come on, and no DTCs are stored 1. Turn the ignition switch ON (II). 2. Check the low pressure indicator for several seconds when the ignition switch is turned ON (II). Did the indicator come on and then go off? YES-Go to step 3. NO-Go to step 8. 3. Turn the ignit

© 2016-2025 Copyright www.hcrv.net