Honda CR-V: Cowl Cover Replacement
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and
Equipment Program; call 888-424-6857
NOTE:
- Put on gloves to protect your hands.
- Take care not to scratch the cowl cover and body.
- Use the appropriate tool from the KTC trim tool set to
avoid damage when prying components.
1. Remove these items:
- Windshield wiper arms
- Front fender trim, both sides
2. From both sides of the cowl cover, release the
hooks (A) from the cowl cover (B) and the front
fender (C), then release the hood hinge cover (D),
then remove the covers.
Driver's side

Passenger's side

3. Remove the rear hood seal (A) by pulling it out.
Using a clip remover, detach the clips from the
cowl covers.

4. Detach the clips (A) by carefully pulling the
passenger's cowl cover (B) upward, and release the
hook (C) on the passenger's cowl cover from the
driver's cowl cover, then release the hooks (D) from
the under cowl panel (E), disconnect the windshield
washer tubes (F), and remove the passenger's cowl
cover.

5. Detach the clips (G) by carefully pulling the driver's
cowl cover (H) upward, then release the hooks (I)
from the under cowl panel, and remove the driver's
cowl cover.
6. Install the covers in the reverse order of removal,
and note these items:
- Make sure the washer tubes are connected
securely.
- Check if the clips are damaged or stress-whitened,
and if necessary, replace them with
new ones.
- Push the clips and hooks into place securely.
READ NEXT:
NOTE:
Take care not to scratch the door.
Put on gloves to protect your hands.
1. Remove these items:
Door panel, front , rear.
Door speaker, front, rear.
2. From the front or the rear door, re
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and
Equipment Program; call 888-424-6857
NOTE:
Put on gloves to protect your hands.
Take care not t
Front Inner Fender Replacement
NOTE: Take care not to scratch the body.
1. Remove the front wheel arch protector, as needed.
2. Remove the front inner fender (A).
Remove the screws (B, C), and remo
SEE MORE:
Special Tools
Fuel Sender Wrench
Fuel Pressure Gauge Attachment Set
Vacuum/Pressure Gauge, 0-4 in.Hg
Pressure Gauge Adapter
Oil Pressure Hose
A/T Pressure Hose
A/T Low Pressure Gauge W/Pane
A/T Pressure Hose, 2,210 mm
A/T Pressure Hose, Adapter
Fuel Pressure Gauge
The National Highway Traffic Safety
Administration and Transport
Canada recommend that all children
aged 12 and under be properly
restrained in a back seat.
If the passenger’s front airbag
inflates in a moderate to severe
frontal collision, the airbag can cause
serious injuries to a
© 2016-2025 Copyright www.hcrv.net
