Honda CR-V: Windshield Wipers and Washers

READ NEXT:

 Windshield Wiper

1. MIST 2. OFF 3. INT Intermittent 4. LO Low speed 5. HI High speed 6. Windshield washers Push the right lever up or down to select a position. MIST - The wipers run at high speed until

 WindshieldWashers

Pull the wiper control lever toward you, and hold it. The washers spray until you release the lever. The wipers run at low speed, then complete one more sweep after you release the lever.

 Rear Window Wiper and Washer

1. OFF When you turn the wiper switch to the ‘‘OFF’’ position, the wiper will return to its parked position. 2. Rotate the switch clockwise to turn the rear window wiper ON. The

SEE MORE:

 Engine Block

Special Tools Oil Seal Driver Attachment, 96 mm Driver Component Location Index BAFFLE PLATE LOVER BLOCK DOWEL PINS CRANKSHAFT OIL SEAL, TRANSMISSION END THRUST WASHERS ENGINE BLOCK CRANKSHAFT MAIN BEARINGS PISTON RINGS PISTON PIN PISTON CONNECTING

 Receiver/Dryer Desiccant Replacement

NOTE: Install the receiver/dryer as quickly as possible to prevent the system from absorbing moisture from the air. 1. Remove the A/C condenser. 2. Remove the cap (A) from the bottom of the A/C condenser. Remove the O-ring (B) and the desiccant (C). 3. Install the receiver/dryer in the reverse or

© 2016-2025 Copyright www.hcrv.net