Honda CR-V: Carbon Monoxide Hazard

Your vehicle’s exhaust contains carbon monoxide gas. Carbon monoxide should not enter the vehicle in normal driving if you maintain your vehicle properly and follow the information on this page.

Have the exhaust system inspected for leaks whenever:

The vehicle is raised for an oil change.

You notice a change in the sound of the exhaust.

The vehicle was in a crash that may have damaged the underside.

Carbon monoxide gas is toxic.

Carbon monoxide gas is toxic.

Breathing it can cause unconsciousness and even kill you.

Avoid any enclosed areas or activities that expose you to carbon monoxide.

High levels of carbon monoxide can collect rapidly in enclosed areas, such as a garage. Do not run the engine with the garage door closed.

Even with the door open, run the engine only long enough to move the vehicle out of the garage.

With the tailgate open, airflow can pull exhaust gas into your vehicle’s interior and create a hazardous condition. If you must drive with the tailgate open, open all the windows and set the heating and cooling system as shown below.

If you must sit in your parked vehicle with the engine running, even in an unconfined area, adjust the heating and cooling system as follows:

1. Select the fresh air mode.

2. Select the 3. Turn the fan on high speed. mode.

3. Turn the fan on high speed.

4. Set the temperature control to a comfortable setting.

READ NEXT:

 Safety Labels

These labels are in the locations shown. They warn you of potential hazards that could cause serious injury or death. Read these labels carefully. If a label comes off or becomes hard to re

 Instruments and Controls

This section gives information about the controls and displays that contribute to the daily operation of your vehicle. All the essential controls are within easy reach. Control Locations

 Gauges

SEE MORE:

 CD, DVD, and PC Card Removal/Installation

If the display will not open, use this procedure to manually open the display and remove the CD, DVD, and/or the PC card. 1. Remove the navigation unit from the vehicle. 2. On the bench, carefully pull the display (A) straight out (about 1/2 inch). 3. Fold down the display as shown in the diagram

 DTC 21-1x ("x" can be 0 thru 9 or A thru F): Open or Increased Resistance in Driver's Seat Belt Tensioner

DTC 21-1x ("x" can be 0 thru 9 or A thru F): Open or Increased Resistance in Driver's Seat Belt Tensioner Special Tools Required  SRS inflator simulator 07SAZ-TB4011A  SRS simulator lead K 070AZ-SNAA200 NOTE: Before doing this troubleshooting procedure, review SRS Precautions and Proce

© 2016-2025 Copyright www.hcrv.net