Honda CR-V: To Remove Exterior Frost or Ice Fromthe Windows
Honda CR-V (2006–2011) Owner's Manual / Features / Vents, Heating, and A/C / To Remove Exterior Frost or Ice Fromthe Windows
1. Select
. The system
automatically switches to fresh air
mode and turns on the A/C.
The A/C indicator does not come on if it was off to start with.
2. Select
.
3. Set the fan and temperature controls to maximum level.
To clear the windows faster, you can close the dashboard corner vents by rotating the wheel below each vent.
This sends more warm air to the windshield defroster vents. Once the windshield is clear, select fresh air mode to avoid fogging the windows.
For your safety, make sure you have a clear view through all the windows before driving.
READ NEXT:
To Turn Everything Off
Turning the fan speed control dial all
the way to the left shuts the system
off.
Keep the system off for short
periods only.
To keep stale air and mustiness
from collecting, you should have
Climate Control System
Climate Control System
Voice Control System
On vehicles with navigation system
The climate control system for your
vehicle can also be operated using
the voice control system. See the
navigation system manual for
complete details.
SEE MORE:
DTC P1157: A/F Sensor (Sensor 1) AFS Circuit
High Voltage
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and review the general
troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Start the engine, and wait 1 minute.
4. Check for Temporary DTCs or DTCs with the HDS.
Is DT
Oil Pan Installation
1. Remove all of the old liquid gasket from the oil pan
mating surfaces, bolts, and bolt holes.
2. Clean and dry the oil pan mating surfaces.
3. Apply liquid gasket, P/N 08717-0004,08718-0001,
08718-0003, or 08718-0009, evenly to the engine
block mating surface of the oil pan and to the inner
thre
© 2016-2025 Copyright www.hcrv.net
