Honda CR-V: To Play the FM/AM Radio

The ignition switch must be in the ACCESSORY (I) or ON (II) position.

Turn the system on by pushing the FM or AM button. Adjust the volume by turning the VOL/SELECT knob.

The band and frequency that the radio was last tuned to are displayed.

To change bands, press the AM or FM button. On the FM band, ST will be displayed if the station is broadcasting in stereo. Stereo reproduction in AM is not available.

READ NEXT:

 To Select a Station

You can use any of five methods to find radio stations on the selected band: tune, seek, scan, the preset buttons, and auto select. TUNE - Use the SEEK button to tune to a desired frequency.

 Adjusting the Sound

Press the sound ( ) button to select an appropriate setting: bass, treble, fader, balance, subwoofer (if equipped), and SVC (speed-sensitive volume compensation). Turn the VOL/SELECT knob

 Audio System Lighting

You can use the instrument panel brightness control knob to adjust the illumination of the audio system. The audio system illuminates when the parking lights are on, even if the system is tu

SEE MORE:

 ATF Level Check

NOTE: Keep all foreign particles out of the transmission. 1. Park the vehicle on the level ground. 2. Warm up the engine to normal operating temperature (the radiator fan comes on), and turn the engine off. Do not allow the engine to warm up longer than the time it takes for the radiator fan to com

 DTC P0716: Problem in Input Shaft (Mainshaft) Speed Sensor Circuit

DTC P0716: Problem in Input Shaft (Mainshaft) Speed Sensor Circuit DTC P0717: Problem in Input Shaft (Mainshaft) Speed Sensor Circuit (No Signal Input) NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. This code is c

© 2016-2026 Copyright www.hcrv.net