Honda CR-V: TripMeter

This meter shows the number of miles (U.S.) or kilometers (Canada) driven since you last reset it.

There are two trip meters: Trip A and Trip B. Switch between these displays by pressing the select/reset knob repeatedly.

Each trip meter works independently, so you can keep track of two different distances.

When you turn the ignition switch to the ON (II) position, the last selection is displayed.

To reset a trip meter, display it, and then press and hold the select/reset knob until the number resets to ‘‘0.0’’.

READ NEXT:

 Instant Fuel Economy

This display shows the instant fuel economy you are getting. It shows the number of mpg (U.S.) or l/100 km (Canada).

 Average Fuel Economy

When either of the trip meters (trip A or B) is displayed, your vehicle’s average fuel economy since you last reset that tripmeter can be shown on the information display (mpg on U.S. mode

 Range (Estimated Distance)

This display shows the estimated distance you can travel on the fuel remaining in the tank. This distance is estimated from the fuel economy you have achieved over the last few miles (kilomet

SEE MORE:

 To Play a PC Card

You operate the PC card player with the same controls used for the radio and the disc player. To load or play a card, the ignition switch must be in the ACCESSORY (I) or ON (II) position. The PC card player reads and plays cards in MP3 or WMA formats. Depending on the format, the scree

 Front Driveshaft Reassembly

Exploded View NOTE: Refer to the Exploded View as needed during this procedure. Inboard Joint Side 1. Wrap the splines with vinyl tape (A) to prevent damaging to the inboard boot. 2. Install the inboard boot onto the drives haft, then remove the vinyl tape. Be careful not to damage the inboard boo

© 2016-2025 Copyright www.hcrv.net