Honda CR-V: Resetting the Engine Oil Life Display

Honda CR-V (2006–2011) Owner's Manual / Maintenance / Maintenance Minder / Resetting the Engine Oil Life Display

Your dealer will reset the display after completing the required maintenance service. You will see ‘‘OIL LIFE 100%’’ on the information display the next time you turn the ignition switch to the ON (II) position.

If maintenance service is done by someone other than your dealer, reset the maintenance minder as follows:

1. Turn the ignition switch to the ON (II) position.

2. Press the select/reset knob repeatedly until the engine oil life is displayed.

3. Press the select/reset knob for

3. Press the select/reset knob for about 10 seconds. The information display shows the resetmode initial display as shown.

4. Select the ‘‘OIL LIFE’’ indicator by turning the select/reset knob. The display begins to blink. Push the same knob to enter this setting.

5. The engine oil life and the

5. The engine oil life and the maintenance item code(s) will begin to blink. Press the select/ reset knob for another 5 seconds.

6. The maintenance item code(s) will disappear, and the engine oil life will reset to ‘‘100.’’

READ NEXT:

 Important Maintenance Precautions

If you have the required service done but do not reset the display, or reset the display without doing the service, the system will not show the correct maintenance intervals. This can lead

 Owner’s Maintenance Checks

You should check the following items at the specified intervals. If you are unsure of how to perform any check, turn to the appropriate page listed. Engine oil level - Check every time you

 Fluid Locations

Fluid Locations

SEE MORE:

 Keys and Locks

The master key fits all the locks on your vehicle. The valet key works only in the ignition and the driver’s door lock. You can keep the glove box locked when you leave your vehicle and the valet key at a parking facility. You should have received a key number tag with your keys

 Shift Cable

Shift Cable Replacement 1. Lift the vehicle up on a lift or apply the parking brake, block rear wheels, and raise the *front of the vehicle. Make sure it is securely supported. 2. Remove the following parts: Heater control panel Dashboard center panel Center lower covers 3. Shift the shift le

© 2016-2025 Copyright www.hcrv.net