Honda CR-V: Compass Zone Selection
In most areas, there is a variation between magnetic north and true north. Zone selection is required so the compass can compensate for this variation. To check and select the zone, do this:
1. Press and hold the select/reset knob for 10 seconds to change the display to the reset mode.
2. Select the zone indicator by turning the select/reset knob. The display begins to blink. Push the same knob to enter this setting.
3. Find the zone for your area on the zone map. Each zone number (1 through 15) corresponds to a compass zone.
4. Turn the select/reset knob to select the appropriate zone number, and press the select/ reset knob to enter the number.
When the system does not accept the selected compass zone, you see ‘‘- -’’ in the direction display. Select appropriate zone number again.
READ NEXT:
Security System
If equipped
The security system helps to protect
your vehicle and valuables from theft.
The horn sounds and a combination
of headlights, parking lights, side
marker lights and taillights flash
Rearview Camera and Monitor
On EX-L model with navigation system
Whenever you shift to reverse (R)
with the ignition switch in the ON
(II) position, the rearview is shown
on the navigation system screen.
For the best p
Cruise Control
Cruise control allows you to maintain
a set speed above 25 mph (40 km/h)
without keeping your foot on the
accelerator pedal. It should be used
for cruising on straight, open
highways. It is
SEE MORE:
EVAP Canister Replacement
1. Lift the vehicle, and support it with jackstands.
2. Remove the cover (A).
3. Remove the EVAP canister baffle cover (A).
4. Disconnect the hoses (A) and the fuel subharness
6P connector (B).
5. Remove the bolts (C) and the EVAP canister bracket
(D).
6. Remove the EVAP canister (A) from the E
Adjusting the Sound
Press the sound (
) button to
select an appropriate setting: bass,
treble, fader, balance, subwoofer (if
equipped), and SVC (speed-sensitive
volume compensation). Turn the
VOL/SELECT knob to adjust the
setting.
BAS - Adjusts the bass.
TREBLE - Adjusts the treble.
FADER - Adjus
