Honda CR-V: Replacing Tires andWheels
Replace your tires with radial tires of the same size, load range, speed rating, and maximum cold tire pressure rating (as shown on the tire’s sidewall).
Mixing radial and bias-ply tires on your vehicle can reduce braking ability, traction, and steering accuracy. Using tires of a different size or construction can cause the ABS and vehicle stability assist system (VSA) to work inconsistently.
The ABS and VSA system work by comparing the speed of each wheel.
When replacing tires, use the same size originally supplied with the vehicle. Tire size and construction can affect wheel speed and may cause the system to activate.
It is best to replace all four tires at the same time. If that is not possible or necessary, replace the two front tires or two rear tires as a pair.
Replacing just one tire can seriously affect your vehicle’s handling.
If you ever replace a wheel, make sure that the wheel’s specifications match those of the original wheels.
Also be sure you use only TPMS specific wheels. If you do not, the tire pressure monitoring system will not work on that tire.
Replacement wheels are available at your dealer.
Installing improper tires on your vehicle can affect handling and stability. This can cause a crash in which you can be seriously hurt or killed.
Always use the size and type of tires recommended in this owner’s manual.
READ NEXT:
Wheel and Tire Specifications
Wheels:
17 x 6 1/2J
Tires:
225/65R17 102T
Winter Driving
Tires marked ‘‘M + S’’ or ‘‘All
Season’’ on the sidewall have an allweather
tread design suitable for
most winter driving conditions.
For the best performance in snowy
or icy
Wheels
Clean the wheels as you would the
rest of the exterior. Wash them with
the same solution, and rinse them
thoroughly.
If equipped
Aluminum alloy wheels have a
protective clear-coat that keeps
SEE MORE:
Alternator and Regulator
Circuit Troubleshooting
1. Make sure the battery connections are good and
the battery is sufficiently charged.
2. Connect a VAT-40 (or equivalent tester), and turn
the selector switch to position 1 (starting).
3. Start the engine. Hold the engine speed at
3,000 rpm with no load until the radiator fan comes
on, then let i
Gauges
Component Location Index
GAUGE CONTROL MODULE
Self-diagnostic Function
Input Test
Rewriting the ODO Data and Transferring Smart
Maintenance on a New Gauge Control Module
Replacement
Outside Air Temperature Indicator Calibration
OUTSIDE AIR TEMPERATURE SENSOR
Test
Replaceme
