Honda CR-V: Auto Door Locking

The auto door locking feature has three possible settings:

The auto door locking is deactivated all the time.

The doors and tailgate lock whenever you move the shift lever out of the Park (P) position.

The doors and tailgate lock when the vehicle speed reaches 9 mph (15 km/h).

This is the default setting.

To turn off the Auto Door Lock modes:

1. Make sure the shift lever is in the

1. Make sure the shift lever is in the Park (P) position.

2. Turn the ignition switch to the ON (II) position, and open the driver’s door.

3. Push and hold the front of the master door lock switch on the driver’s door until you hear a click (after about 5 seconds).

4. Release the switch, and within 20 seconds, turn the ignition switch to the LOCK (0) position.

To program the Park Lock mode:

Locks all doors and tailgate when the shift lever is moved out of the Park (P) position.

1. Make sure the shift lever is in the

1. Make sure the shift lever is in the Park (P) position.

2. Turn the ignition switch to the ON (II) position, and make sure to close the driver’s door.

3. Push and hold the front of the master door lock switch on the driver’s door. You will hear a click.

Keep holding the switch until you hear another click (after about 5 seconds).

4. Release the switch, and within 20 seconds, turn the ignition switch to the LOCK (0) position.

To program the Drive Lock mode:

Locks all doors and tailgate when the vehicle’s speed reaches about 9 mph (15 km/h).

1. Make sure the shift lever is in the

1. Make sure the shift lever is in the Park (P) position.

2. Turn the ignition switch to the ON (II) position, and make sure to close the driver’s door.

3. Push and hold the brake pedal, and move the shift lever out of the Park (P) position.

4. Push and hold the front of the master door lock switch on the driver’s door. You will hear a click.

Keep holding the switch until you hear another click (after about 5 seconds).

5. Release the switch, and within 20 seconds, turn the ignition switch to the ACCESSORY (I) position.

Move the shift lever to the Park (P) position.

6. Turn the ignition switch to the LOCK (0) position.

READ NEXT:

 Auto Door Unlocking

The auto door unlocking feature has five possible settings: The auto door unlocking is deactivated all the time. The driver’s door unlocks when you move the shift lever to the Park (P) pos

 Childproof Door Locks

The childproof door locks are designed to prevent children seated in the rear from accidentally opening the rear doors. Each rear door has a lock lever near the edge. With the lever in t

 Remote Transmitter

LOCK - Press this button once to lock all doors and the tailgate. Some exterior lights will flash once. When you push LOCK twice within 5 seconds, you will hear a beep to verify that the

SEE MORE:

 Differential Disassembly

Special Tools Required Holder handle 07JAB-001020A Companion flange holder 07RAB-TB4010B 1. Remove the drain plug (A) and the oil filler plug (B) with sealing washers (C). 2. Raise the locknut tab (A) from the groove of the clutch guide, making sure the tab completely clears the groove to preve

 Symptom Troubleshooting

Hard Steering 1. Check the power assist. Is the initial turning load more than 34 N (3.5 kgf, 7.7 Ibf) ? YES-Go to step 2. NO-Power assist is OK. 2. Connect the P/S joint adapter (pump), P/S joint adapter (hose), and P/S pressure gauge T/N 07406- 0010001 (see page 17-9), T/N 07406-001000A or T/N

© 2016-2025 Copyright www.hcrv.net