Honda CR-V: Audio Antenna

Your vehicle is equipped with an

Your vehicle is equipped with an antenna at the rear of the roof . Bef ore using a ‘‘drive-through’’ car wash, remove the antenna by unscrewing it by hand. This prevents the antenna f rom being damaged by the car wash brushes.

READ NEXT:

 Dust and Pollen Filter

This filter removes the dust and pollen that is brought in fromthe outside through the heating and cooling system/climate control system. Have your dealer replace this filter when this serv

 Wiper Blades

Check the condition of the wiper blades at least every six months. Replace them if you find signs of cracking in the rubber, areas that are getting hard, or if they leave streaks and unwiped

 Tires

To safely operate your vehicle, your tires must be the proper type and size, in good condition with adequate tread, and correctly inflated. The following pages give more detailed information

SEE MORE:

 Block and Piston Inspection

1. Remove the crankshaft and pistons. 2. Check the piston for distortion or cracks. 3. Measure the piston diameter at a point 13 mm (0.5 in.) from the bottom of the skirt. There are two standard-size pistons (No Letter or A, and B). The letter is stamped on the top of the piston. Letters are also

 VTC Actuator, Exhaust Camshaft Sprocket Replacement

Removal 1. Remove the cam chain. 2. Hold the camshaft with an open-end wrench, then loosen the variable valve timing control (VTC) actuator mounting bolt and exhaust camshaft sprocket mounting bolt. 3. If the VTC actuator will be reused, do these steps. Remove the intake camshaft, and seal the

© 2016-2025 Copyright www.hcrv.net