Honda CR-V manuals

Honda CR-V: Additional Information on Recommended Discs

Honda CR-V (2006–2011) Owner's Manual / Features / Protecting Your Discs / Additional Information on Recommended Discs

The disc player/changer has a sophisticated and delicate mechanism. If you insert a damaged disc as indicated in this section, it may become stuck inside and damage the audio unit.

Examples of these discs are shown to the right:

1. Bubbled, wrinkled, labeled, and excessively thick discs

1. Bubbled, wrinkled, labeled, and excessively thick discs

2. Damaged discs

2. Damaged discs

3. Poor quality discs

3. Poor quality discs

4. Small, irregular shaped discs

4. Small, irregular shaped discs

5. Discs with scratches, dirty discs

5. Discs with scratches, dirty discs

CD-R or CD-RW may not play due to the recording conditions.

Scratches and fingerprints on the discs may cause the sound to skip.

Recommended discs are printed

Recommended discs are printed with the following logo.

Audio unit may not play the

Audio unit may not play the following formats.

READ NEXT:

 Remote Audio Controls

If equipped Three controls for the audio system are mounted in the steering wheel hub. These let you control basic functions without removing your hand from the wheel. The VOL button adjus

 Playing an Optional Audio Unit

Your vehicle has the auxiliary input jack on the front panel, on the center table, or in the console compartment, depending on models. The system will accept auxiliary input from standard

 Radio Theft Protection

Your vehicle’s audio system will disable itself if it is disconnected from electrical power for any reason. To make it work again, you must enter a specific code using the preset buttons (i

SEE MORE:

 Braking System

Your vehicle is equipped with disc brakes at all four wheels. A power assist helps reduce the effort needed on the brake pedal. The anti-lock brake system (ABS) helps you retain steering control when braking very hard. Resting your foot on the pedal keeps the brakes applied lightly, b

 Driveshaft Inspection

1. Check the inboard boot (A) and the outboard boot (B) on the driveshaft (C) for cracks, damage, leaking grease, and loose boot bands (D). If any damage is found, replace the boot and boot bands. 2. Turn the driveshaft by hand, and make sure the splines (E) and joint are not excessively loose. 3.

© 2016-2025 Copyright www.hcrv.net