Honda CR-V: Sunvisor Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program; call 888-424-6857
NOTE:
- Put on gloves to protect your hands.
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- Take care not to scratch the headliner.
1. From both sides, using a trim tool, release the tabs (A) from the bracket (B).
2. Remove the sunvisor cap (A) from the bracket (B).
Turn the cap, and remove it.
3. Remove the sunvisor (A).
- Using a T25 TORX bit, remove the screws.
- Remove the sunvisor from the body and holder (B).
4. Using a flat-tip screwdriver, push the hook (A), and turn the holder (B) 90º , then pull it out.
5. Install the sunvisor in the reverse order of removal, and note these items:
- If the side curtain airbag has deployed, replace the sunvisor with a new one.
- To prevent the side curtain airbags from
deploying improperly and possibly causing
injury, inspect removed pieces and replace them
if they have any of these types of damage:
- Any cracks in the sunvisor stay base (A)
- Any bends or cracks in the sunvisor stay shaft (B)
- Any cracks in the sunvisor base (C)
- Any cracks or breakage in the vanity mirror base (D)
Grab Handle Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program; call 888-424-6857
NOTE: Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
1. Lower the grab handle (A), then pull out the covers (B).
2. While pinching the clips (A), release the hooks (B), then remove the grab handle (C).
3. Using a pair of pliers, remove all of the clips (A) by pinching its hooks.
4. If the side curtain airbag has deployed, replace the grab handle with a new one.
5. If the side curtain airbag has not deployed, to prevent the side curtain airbags from deploying improperly and possibly causing injury, inspect removed pieces and replace them if they have any of these types of damage:
- Any cracks or breakage in the grab handle (A).
- Any cracked or stress-whitening in the covers (B).
6. Install the clips (A) to the grab handle (B), then install the covers (C) fully into the clips.
7. Position the grab handle (A) on the bracket (B), and push on the grab handle until the clips (C) snap into place securely.
READ NEXT:
Headliner Removal/Installation
SRS components are located in this area. Review the SRS component locations
and the precautions and procedures before
doing repairs or service.
NOTE:
Put on gloves to protect your hands.
Use the a
Consoles
Center Console Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and
Equipment Program; call 888-424-6857
SRS components are locate
SEE MORE:
Text Data Display Function
Each time you press the TITLE
button, the display mode shows you
in sequence, the folder name, the file
name, the artist name, the album
name, the song name, or name off
(which turns off the text display).
The display shows up to 16
characters of the selected data. If the
text data ha
Replacing Tires andWheels
Replace your tires with radial tires of
the same size, load range, speed
rating, and maximum cold tire
pressure rating (as shown on the
tire’s sidewall).
Mixing radial and bias-ply tires on
your vehicle can reduce braking
ability, traction, and steering
accuracy. Using tires of a di
