Honda CR-V: Floor Mats

The floor mats that came with your

The floor mats that came with your vehicle hook over the floor mat anchors. This keeps the floor mats from sliding forward, possibly interfering with the pedals, or backwards, making the front passenger’s weight sensors ineffective.

If you remove a floor mat, make sure to re-anchor it when you put it back in your vehicle.

If you use a non-Honda floor mat, make sure it fits properly and that it can be used with the floormat anchors. Do not put additional floor mats on top of the anchored mats.

READ NEXT:

 Audio Antenna

Your vehicle is equipped with an antenna at the rear of the roof . Bef ore using a ‘‘drive-through’’ car wash, remove the antenna by unscrewing it by hand. This prevents the antenna

 Dust and Pollen Filter

This filter removes the dust and pollen that is brought in fromthe outside through the heating and cooling system/climate control system. Have your dealer replace this filter when this serv

 Wiper Blades

Check the condition of the wiper blades at least every six months. Replace them if you find signs of cracking in the rubber, areas that are getting hard, or if they leave streaks and unwiped

SEE MORE:

 EGR Passage Removal and Installation

Removal 1. Drain the engine coolant. 2. Remove the air cleaner housing. 3. Remove the harness holder (A) from the bracket, then remove the harness holder bracket (B). 4. Remove the upper radiator hose (A), heater hose (B), and water bypass hose (C). 5. Remove the air cleaner housing brackets. 6

 PCM Replacement

NOTE: Make sure the HDS is loaded with the latest software version. If you are replacing the PCM after substituting a known-good PCM, reinstall the original PCM, then do this procedure. During the procedure, is any READ DATA, WRITE DATA, or other data checks fail, note the failure, then con

© 2016-2026 Copyright www.hcrv.net