Honda CR-V: Accessory Power Sockets
Honda CR-V (2006–2011) Owner's Manual / Instruments and Controls / Interior Convenience Items / Accessory Power Sockets
Your vehicle has two or three accessory power sockets depending on the model.
To use an accessory power socket, the ignition switch must be in the ACCESSORY (I) or ON (II) position.
Each socket is intended to supply power for 12 volt DC accessories that are rated 120 watts or less (10 amps).
None of the sockets will power an automotive type cigarette lighter element.
Make sure to put the socket cover back in place to prevent any small foreign objects from getting into the socket.
READ NEXT:
Console Compartment
EX-L model
Push the release knob to open or
close the console compartment, slide
the lid rearward.
Coat Hook
To use a coat hook, slide it out
slightly, then pull it down.
Make sure the coat hook is folded up
when you are not using it. This hook
is not designed for large or heavy
items.
Seat Under Tray
If equipped
Your vehicle has a seat under tray
located under the front passenger
seat. Use the tray by pulling on the
front center edge of the tray.
SEE MORE:
Piston Ring Replacement
1. Remove the piston from the engine block.
2. Using a ring expander (A), remove the old piston
rings (B).
3. Clean all ring grooves thoroughly with a squared-off
broken ring or ring groove cleaner with a blade
to fit the piston grooves.
The top and 2nd ring grooves are 1.2 mm (0.05 in.)
wide. Th
Introduction
How to Use This Manual
This manual is divided into multiple sections. The first page of
each section is marked with a black tab that lines up with its
corresponding thumb index tab on this page and the back cover.
You can quickly find the first page of each section without
looking through a full ta
© 2016-2025 Copyright www.hcrv.net
